Product Categories
Social Media
Home > News > Content
What Are The Obvious Changes In The Casting Of The Current Mold Production Of Ceramic Products?
- Nov 06, 2017 -

What are the obvious changes in the casting of the current Mold Production Of Ceramic Products?
As far as the current Mold Production Of Ceramic Products are concerned with casting, the first thing we should pay attention to is the equipment on forging. In this regard, if it is based on the differences in the forgings, in terms of its short hammers for Mold Production Of Ceramic Products, we actually have to be careful about the choice of tonnage.
It is also for this reason that, before it was forged, it was in fact that we should take note of the fact that it was straightforward to carry out the preheating of hammer and hammerheads directly on Mold Production Of Ceramic Products In fact, it is very important. In this respect, we must not neglect anybody when carrying out the processing.
In addition, we actually need to pay attention to the blank preparation for Mold Production Of Ceramic Products, in terms of the blank itself, the best thing we should do when it comes to cutting is that it should be However, at this point, we actually have to pay attention to the differences that should be made according to the different types of Mold Production Of Ceramic Products.
When choosing the raw materials of Mold Production Of Ceramic Products, we actually should pay attention to the fact that we should classify the carbides above the grade in advance. Then we actually need to pay attention to the choice of suitable Forging process of a series of carbides, under normal circumstances, when pulled in three times per ton, we actually should pay attention to be able to progress 1-1.5 level.
In the end, we actually should pay attention to the blanks should be directly related to the heating behavior. In terms of the entire heating process, in fact, to a large extent, it should be noted that it should be carried out slowly. To a large extent, this is in fact a situation that can prevent its rapid heating up. As a result, Cast Production Of Ceramic Products can be cast to avoid over-burning.
The abrasion resistance of the material is one of the most important properties of Mold Production Of Ceramic Products. Next, we actually pay attention to the hardness itself, that is, one of the main factors that will affect the wear resistance. In general, the higher the hardness of a Mold Production Of Ceramic Products part, the less wear it will have and the better wear resistance.
On the other hand, in fact, we should pay attention to the fact that the wear resistance itself is actually related to the type and amount of carbides in the material, as well as its shape, size and distribution. Furthermore, on the other hand, when it comes to choosing Mold Production Of Ceramic Products, it is in itself that there should be good toughness.
Mold Production Of Ceramic Products In the long-term role of cyclic stress, it is actually necessary to pay attention to the need to withstand multiple impacts, and precisely because of this, in fact, we should also pay attention to itself, that is, Faced with a large impact load, so that will be more likely to lead to its rupture behavior.
Therefore, in order to prevent Mold Production Of Ceramic Products parts at work when a sudden break phenomenon, in terms of the mold itself, in fact, it should be that it will have a higher strength and toughness. However, in fact, we should pay attention to the toughness of the mold is concerned, to a large extent, it also depends on the material itself, a carbon content and its grain size and the state of the organization and the content of inclusions and strength.
There are some Mold Production Of Ceramic Products, such as plastic mold in the work of the time, to a large extent, in fact, there is a plastic chloride, fluorine and other elements, in view of this, we actually would not mind that it After heated, that is, will decompose the HCI, HF and other highly aggressive gases, so that to a certain extent, it will erode the mold cavity surface, so that it increases the surface roughness, exacerbated Wear and tear failure.